![]() If you can read out CV30, this gives information about the cause of the short circuit. At the next start-up, first the short circuit are verified, if it does not appear anymore, the decoder will start a normal operation. In case of a short circuit, the decoder goes in a protection state, and disables the motor/AUX outputs. But if you know that by default F1 activates AUX1, F2 activates AUX2 etc, it will be helpful to understand this.Ģ) Decoder damage protection A: Under normal circumstances, there is no reason for the decoder to be damaged, it has quite high current capability, and internal protection (on the motor outputs and AUX outputs too). It can take some figuring out to which connection each light is connected. You do this by finding the CV value from CV 33 and onwards. If only the lights turn on on one side of the model, when you press a F key, but you want both front and rear lights to turn on, you have to tell the CV belonging to that key to enable that connected light as well. A: The Function keys can be programmed to enable different connected lights. If you have value 16 in both CV 40 and 41, both F5 and F6 will activate AUX3.ġ) Only front or rear light is on, when pressing light or Function key. (page 86) If you want F6 to enable AUX3, you have to enter value 16 in CV 41 (page 87). ![]() Let's say you want the AUX3 connection on the decoder to become active when pressing F5, you have to enter the value of 16 in CV 40. If you want to assign another output function, you need to address the Lokommander II manual, pages 79 to page 93. They can be a a physical cable (white, yellow, green, purple for example) on the decoder or a pin on the cable-less decoders. If you would like to know more about what we do to make sure only 100% working decoders are being shipped to our customers, read all about our test process here.Ġ) GENERAL INSTRUCTIONS ABOUT REMAPPING THE OUTPUT FUNCTIONS (AUX): Output functions are also called AUX outputs. If your decoder is not working anymore, some of the information below might help you solve the problem. Which means, only tested and working decoders leave our factory. At that time, the basic functionality is tested again. Later, before delivery, if it is the case, the decoders are updated with the latest released firmware. ![]() ![]() All the decoders has to pass this test, and as a result they are validated. This software was improved over the years, and it is used to validate each decoders hardware before it gets the latest firmware and is shipped. We test all decoders automatically, with a test bench and a dedicated software made by us. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |